Heating and Boiler Plans - Standard Residential

21-Plus Furnace Clean & Check $131 Value for only $99.00 Test thermostat - turn on heat Visually inspect flue pipe Test draft in flue (cold) Remove and clean burners Remove and clean pilot Remove and clean flame sensor Remove and clean spark ignitor Replace thermocouple (additional cost) Test hot surface ignitor Replace if needed (additional cost depending on brand) Clean heat exchanger Inspect heat exchanger for cracks and stress Vacuum burner compartment and exchanger Re-assemble unit Test for gas leaks at unit Inspect filter change if needed (customer provides) Inspect blower Oil blower motor if needed Remove and clean blower if needed (time and material extra) Inspect and tighten electrical connections Start heat Watch for smooth ignition Test temperature rise Adjust to manufacturers rating Test draft Test carbon monoxide Test and inspect safeties Turn off thermostat and test for proper off cycling

10-Point Furnace Safety Inspection Only $74.95 Inspect flue pipes (furnace and water heaters) Inspect burners Inspect filter Inspect boiler Cursory heat exchanger inspection (burners in place) Start unit Inspect flame Test for carbon monoxide Test draft at diverters Make recommendations 11-Point Boiler Safety Inspection Only $74.95 Inspect flue pipes Inspect burners Inspect boiler jacket for signs of flue gas leaks Flame test jacket for flue leaks Inspect system for water leaks Start unit Inspect flames burners and pilot Test draft Test carbon monoxide Inspect and test limits Make recommendations (give estimate of repairs)      Call For Boiler Cleanings